650Rider, xs650 hosted by XS650.com

What Happened to 650rider.com?

650 Rider went offline for about a month at the beginning of 2010. In order to save the technical information that was here, XS650.com acquired the site and brought it back online as a read-only archive. If you were a member of 650 Rider, you will need to re-register at XS650.com

Search 650Rider.com and XS650.com using Google!

        650Rider Menu
 Community  Information


xs650 > > Motorcycle Systems > > Fuel > > Vm 34s with no choke


Vm 34s with no choke
    Forum Index -> Fuel
Author Message
Razar
Full Member
Full Member


Joined: Jul 03, 2008
Posts: 103
Location: North Coast New South Wales Australia

PostPosted: April 20, 2009, 8:50 pm    Post subject: Vm 34s with no choke

Where ignorance is bliss tis folly to be wise! Unfortunately in this case I'm not so sure.

I picked up a pair of Vm34s for what apeared to be a good price off fleabay a while back .I pulled them out to check out the jetting etc before putting them on the bike, and discovered when comparing them to the diagrams that the start/choke lever and it's guts aren't there. Question

Are these any use, or have I been suckered? Embarassed

_________________
There's more than one way to skin a cat.
Back to top
yamaman
Support Staff
Support Staff


Joined: Jan 04, 2007
Posts: 1638
Location: Perth Western Australia

PostPosted: April 20, 2009, 9:48 pm    Post subject: Re: Vm 34s with no choke

Interesting Razar, what exactly do you have?
Just a hole where the plungers meant to be, or is it blocked off somehow?
You can buy all the bits you need, if it comes to that.
If the carbs are off a snowmobile, you usually have to change the enrichener jet. Also slide cut away can be an issue. Of course jet needles & needle jets might be wrong.

I take it you've got this:

www.mikuni.com/pdf/vmmanual.pdf

There's 3 types of enrichener actuators, the lever that you most likely have seen in the drawings, the pull up type & a cable actuated type. They all do the same thing though, which is lift the plunger to open the enrichener circuit!

Be interesting to know what you have inside and where they came from!

Choke is only needed under 20*C if that helps!

Ian Williams Tuning is the spot for VM bits in Aus, you'll need your credit card however!

www.iwt.com.au/carbdrawings.htm

_________________
Its not enough to have an aim in life, you have to pull the trigger!
Back to top
Photo Gallery
Razar
Full Member
Full Member


Joined: Jul 03, 2008
Posts: 103
Location: North Coast New South Wales Australia

PostPosted: April 20, 2009, 10:08 pm    Post subject: Re: Vm 34s with no choke

Thanks Yamaman. When I say not there I mean the casting has all the provisions, but it has never been drilled.

If you don't need a choke over 20C, They may be OK, as it doesn't go below that here except in the dead of winter.

_________________
There's more than one way to skin a cat.
Back to top
yamaman
Support Staff
Support Staff


Joined: Jan 04, 2007
Posts: 1638
Location: Perth Western Australia

PostPosted: April 20, 2009, 10:22 pm    Post subject: Re: Vm 34s with no choke

Well I guess they're not off a snowmobile then!
Hope it works out.

Be good if you could post all that you have in there, jets, slide pilots ect.

Cheers

_________________
Its not enough to have an aim in life, you have to pull the trigger!
Back to top
Photo Gallery
 
    Forum Index -> Fuel All times are GMT - 5 Hours
Page 1 of 1


 
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


   


Check out the new Honda CB750 Forum at CB750.com! A site dedicated to the great Honda SOHC and DOHC CB750.

Check out the new Yamaha XS400 Forum at XS400.com!

Yamaha xs650

xs650, xs, 650, forum, links, chopper, custom, yamaha, parts, forum, info, information, bb, bulletin board, XS650
650Rider, Free Unrestricted xs650 forum, Personal photo albums, Post images in Forum, News columns, Daily blog, Links, Event calendar, Information for Yamaha XS650



Interactive software released under GNU GPL, Code Credits, Privacy Policy