Author |
Message |
Topic: Standard tank on a Special bike |
Imcgyver
Replies: 13
Views: 10771
|
Forum: Fuel Posted: December 20, 2009, 5:11 pm Subject: Re: Standard tank on a Special bike |
Hello I was wondering what the capacity difference was between the standard and the special tank? |
Topic: Pamco Ignition - No spark, anyone else? |
Imcgyver
Replies: 34
Views: 28883
|
Forum: Pamco - Electronic Ignitions Posted: December 1, 2009, 12:03 pm Subject: Re: Pamco Ignition - No spark, anyone else? |
Thank you for your response, the picture is a great help. |
Topic: Pamco Ignition - No spark, anyone else? |
Imcgyver
Replies: 34
Views: 28883
|
Forum: Pamco - Electronic Ignitions Posted: November 30, 2009, 7:27 pm Subject: Re: Pamco Ignition - No spark, anyone else? |
Hello, this question is for buckroseau, I also have an81H and looking at the Pamco setup with rhe green coil, Will the coil mount on the factory frame mount or will I need to get the ground clamps?
T ... |
Topic: Spark plug indexing |
Imcgyver
Replies: 6
Views: 2303
|
Forum: Electrical Posted: August 23, 2009, 11:32 am Subject: Spark plug indexing |
Hello I was talking with Harley and Kawasaki friends and came up with the subject of spark plug indexing, any xs owners try this and what results? I have a set of washers and am considering trying it. ... |
Topic: BS34 carbs on a 750 big bore kit |
Imcgyver
Replies: 2
Views: 1402
|
Forum: Fuel Posted: July 20, 2009, 2:20 pm Subject: BS34 carbs on a 750 big bore kit |
Hello I am getting another 81H with a bad ring motor, planning on buying the 750 bore kit. The question is to start with I am leaving all stock exhaust and air filter setup with BS34 carbs, what shoul ... |
Topic: xsjohn BS34 needles |
Imcgyver
Replies: 13
Views: 2867
|
Forum: Fuel Posted: May 21, 2009, 10:54 am Subject: Re: xsjohn BS34 needles |
Got the needles yesterday, forcasting rain for the next 7 days will try to get them in and test ride between rain storms, will update on progress and temp changes. |
Topic: xsjohn BS34 needles |
Imcgyver
Replies: 13
Views: 2867
|
Forum: Fuel Posted: May 15, 2009, 11:04 am Subject: xsjohn BS34 needles |
Hello, I am looking at the xsjohn needles for a 1981h with BS34 carbs and was wondering what setting to use for a total stock bike? What kind of performance change would I exspect at what setting? I a ... |
Topic: Cuts out on acceleration |
Imcgyver
Replies: 6
Views: 1893
|
Forum: Fuel Posted: May 7, 2009, 2:55 pm Subject: Re: Cuts out on acceleration |
Solved my fuel problem, adjust valves (10000 mile maintanance schedual) which I found too tight, adjuster surface and valve tip good on all, put teflon tape on needle seat, oring were leaking replacem ... |
Topic: valve tick |
Imcgyver
Replies: 19
Views: 4357
|
Forum: Engine Posted: May 2, 2009, 5:59 pm Subject: Re: valve tick |
What is the best fix? Pilot jet size or?
Thank you for your time and response Ron |
Topic: mixture screw oring |
Imcgyver
Replies: 1
Views: 798
|
Forum: Fuel Posted: April 20, 2009, 8:32 pm Subject: mixture screw oring |
Hello, anyone know what the mixture screw oring size is for the BS34 carbs? I need the orings but nothing else, have enough spare parts on the shelf.
Thank you for your response Ron
1981 XS650II |
Topic: Cuts out on acceleration |
Imcgyver
Replies: 6
Views: 1893
|
Forum: Fuel Posted: February 26, 2009, 10:41 pm Subject: Cuts out on acceleration |
Hello, I have a 81H and was running great until I lost my alternator due to bad rotor, had the rotor done by Custom Rewind great charging now, but on acceleration when cold or warming up it cuts out, ... |
Topic: Alternator brushes |
Imcgyver
Replies: 9
Views: 1836
|
Forum: Electrical Posted: November 9, 2008, 3:05 pm Subject: Alternator brushes |
Hello, I am hearing alot about alt brushes, and was wondering where is the best place to get new ones? Mikesxs, 650Centeral or?
My old ones are still ok I just want to plan ahead.
Thank you for your ... |
Topic: Viberation |
Imcgyver
Replies: 4
Views: 1099
|
Forum: Fuel Posted: June 28, 2008, 8:38 pm Subject: Re: Viberation |
I checked the carbs for sync they are sync, I tried to recreate the problem with the gauges hooked up but could not do it, will try later to ride with the gauges hooked up to see what happens, on the ... |
Topic: Anybody Live in Colorado |
Imcgyver
Replies: 4
Views: 769
|
Forum: Introduce yourself to the community here Posted: June 24, 2008, 8:59 pm Subject: Re: Anybody Live in Colorado |
I have a stock 81 Special II and live in Englewood. |
Topic: Viberation |
Imcgyver
Replies: 4
Views: 1099
|
Forum: Fuel Posted: June 24, 2008, 8:41 pm Subject: Viberation |
I have a 1981 XS650, the problem is in any gear between 3K and 4K RPM it acts like the carbs are out of sync if i let off or throttle up lust a little it goes away then I can go up or down in that ran ... |
|