Author |
Message |
Topic: what oil and new oil filter? |
estewart
Replies: 3
Views: 4345
|
Forum: Engine Posted: December 28, 2009, 3:19 pm Subject: Re: what oil and new oil filter? |
ok, i was going to replace the sump filter with mikesxs modified one. but the parts guy said to clean the side filter, but that flew up a red flag, so i thought id ask. |
Topic: what oil and new oil filter? |
estewart
Replies: 3
Views: 4345
|
Forum: Engine Posted: December 28, 2009, 2:16 pm Subject: what oil and new oil filter? |
hey there, i nee thoughts and opinions...
so i was going to do an oil change on my bike, but the only motorcycle shop open today doesnt have yamalube. does it matter what brand you use as long as i ... |
Topic: engine will only start with starting fluid -runs- then dies |
estewart
Replies: 15
Views: 12023
|
Forum: Engine Posted: December 27, 2009, 11:39 am Subject: Re: engine will only start with starting fluid -runs- then dies |
yeah i learned quite a bit on this topic. some of what you said was a bit over my head but it will eventually click and all make sence.
but thanks to all that helped out. i appreciate it. |
Topic: engine will only start with starting fluid -runs- then dies |
estewart
Replies: 15
Views: 12023
|
Forum: Engine Posted: December 27, 2009, 12:56 am Subject: Re: engine will only start with starting fluid -runs- then dies |
ok, there was fuel sitting in them for a while but when i took the carbs appart they were pretty clean inside, but being a newbie to carbs and all that i'll take your word for it and check them out. b ... |
Topic: engine will only start with starting fluid -runs- then dies |
estewart
Replies: 15
Views: 12023
|
Forum: Engine Posted: December 26, 2009, 11:39 pm Subject: Re: engine will only start with starting fluid -runs- then dies |
XSJOHN- i removed the air/fuel screw, the diaphram and needle, the main jets and the float system. are you talking about the guide that the needle slides into? cuz when i took the diaphams out i spray ... |
Topic: engine will only start with starting fluid -runs- then dies |
estewart
Replies: 15
Views: 12023
|
Forum: Engine Posted: December 26, 2009, 8:54 pm Subject: Re: engine will only start with starting fluid -runs- then dies |
so i cleaned the carbs out with break clean. (i dont have an air compressor) put em back on, and about 8 kicks later and one final use of starting fluid it now starts
now ive got to do the next ... |
Topic: Advice on cleaning wiring sytem |
estewart
Replies: 8
Views: 9094
|
Forum: All the rest Posted: December 25, 2009, 4:05 pm Subject: Re: Advice on cleaning wiring sytem |
i rebuilt my bike because the wiring was starting to go like yours, i took it all off and tossed it. i figured what the heck, i'm up for a challenge and made a wire harness. took me a few tries but ov ... |
Topic: Pint question |
estewart
Replies: 7
Views: 6137
|
Forum: All the rest Posted: December 25, 2009, 3:59 pm Subject: Re: Pint question |
why not buy some car paint that has metal flake already in it. i painted a 06 ex500 with GM charcol. it was black with the metal flake in it. and it didnt cost me an arm and a leg for a pint. haha. it ... |
Topic: need a pick-up coil. where do i get one? |
estewart
Replies: 7
Views: 7318
|
Forum: Electrical Posted: December 24, 2009, 5:23 pm Subject: Re: need a pick-up coil. where do i get one? |
haha, its funy how we sometimes just glance at the book and assume we know what its talking about.
oh, and i got a reply back from the seller of the ebay item, he checked it (correctly) and its re ... |
Topic: need a pick-up coil. where do i get one? |
estewart
Replies: 7
Views: 7318
|
Forum: Electrical Posted: December 24, 2009, 3:43 pm Subject: Re: need a pick-up coil. where do i get one? |
ok, turns out i didnt test the coil properly, i just picked 2 wires and checked it. i looked at the book again and tested it correctly, results..... under 700 ohms. wohoo!!! but the ignition coil is s ... |
Topic: engine will only start with starting fluid -runs- then dies |
estewart
Replies: 15
Views: 12023
|
Forum: Engine Posted: December 24, 2009, 12:57 pm Subject: Re: engine will only start with starting fluid -runs- then dies |
ok, thanks, i'll take them off today and see what i can do. |
Topic: engine will only start with starting fluid -runs- then dies |
estewart
Replies: 15
Views: 12023
|
Forum: Engine Posted: December 24, 2009, 6:43 am Subject: engine will only start with starting fluid -runs- then dies |
i just rewired my bike after a rebuild (everything except the motor itself) new wires and the sale tci and regulator. i finally got it to start tonight. at first i was having trouble and tested the pi ... |
Topic: need a pick-up coil. where do i get one? |
estewart
Replies: 7
Views: 7318
|
Forum: Electrical Posted: December 23, 2009, 11:10 pm Subject: Re: need a pick-up coil. where do i get one? |
ok, that makes sense. the 82 does have a sidestand switch but like you said i dont see it having any problem affecting the system.
also this is the second time i wired the bike up and the first ti ... |
Topic: need a pick-up coil. where do i get one? |
estewart
Replies: 7
Views: 7318
|
Forum: Electrical Posted: December 23, 2009, 10:49 pm Subject: Re: need a pick-up coil. where do i get one? |
thank you!!!
will it work on an 82? i'm assuming it will because you sent me the link but i have to ask. i'm also looking on ebay for the whole stator and not just the pick up coil and i'm finding a ... |
Topic: need a pick-up coil. where do i get one? |
estewart
Replies: 7
Views: 7318
|
Forum: Electrical Posted: December 23, 2009, 10:39 pm Subject: need a pick-up coil. where do i get one? |
i just finished a rebuild and rewired the bike using the stock diagram. i only wired what was necessary to make the bike start up and run, and what do ya know... it wont.
so i check and do diagno ... |
Topic: What gauge wire |
estewart
Replies: 3
Views: 7896
|
Forum: Electrical Posted: December 20, 2009, 12:15 am Subject: Re: What gauge wire |
same here, i'm about to go buy the wire to make my own harness, but what gauge wire do you use? |
Topic: wiring for a bobber |
estewart
Replies: 5
Views: 3741
|
Forum: Electrical Posted: November 25, 2009, 1:52 pm Subject: Re: wiring for a bobber |
ok, so now its just a mater of looking at the wiring now and seeing how its all put together. and figuring out what it what.
thanks. |
Topic: wiring for a bobber |
estewart
Replies: 5
Views: 3741
|
Forum: Electrical Posted: November 25, 2009, 3:41 am Subject: Re: wiring for a bobber |
ok, ive found a couple so far and a few i really like but they say to use an electric ignition unit, what year did the xs start using electric ignition.
i have a stock 82 xs650sj and it runs fine. s ... |
Topic: wiring for a bobber |
estewart
Replies: 6
Views: 4491
|
Forum: Did you say Bob? No I said Bobber! Posted: November 9, 2009, 9:03 pm Subject: Re: wiring for a bobber |
thanks guys, i was looking around for other ideas and saw that barely any of the choppers or bobbers have the turn signals or the other stuff. just the head/tail light, charging system, and the igniti ... |
Topic: "Bad penny" |
estewart
Replies: 28
Views: 26139
|
Forum: Did you say Bob? No I said Bobber! Posted: November 9, 2009, 12:38 pm Subject: Re: "Bad penny" |
thats a beautiful bike. i love the rims... |
Topic: wiring for a bobber |
estewart
Replies: 6
Views: 4491
|
Forum: Did you say Bob? No I said Bobber! Posted: November 9, 2009, 12:35 pm Subject: wiring for a bobber |
hey guys, I got a 82' xs650sj and I'm about to start on my bike project. i want to bob it with the weld on hard tail from TC bros and completely rebuild the bike, and the one thing that has me pretty ... |
Topic: wiring for a bobber |
estewart
Replies: 5
Views: 3741
|
Forum: Electrical Posted: November 9, 2009, 12:33 pm Subject: wiring for a bobber |
hey guys, I got a 82' xs650sj and I'm about to start on my bike project. i want to bob it with the weld on hard tail from TC bros and completely rebuild the bike, and the one thing that has me pretty ... |
Topic: Jim's Hard Tail Project |
estewart
Replies: 34
Views: 18772
|
Forum: Did you say Bob? No I said Bobber! Posted: November 9, 2009, 12:17 pm Subject: Re: Jim's Hard Tail Project |
about the lowering issue, couldn't you slide the shocks up on the triple trees to the ride height you want? |
Topic: new guy from vancouver wa |
estewart
Replies: 1
Views: 1031
|
Forum: Introduce yourself to the community here Posted: December 12, 2008, 10:00 pm Subject: new guy from vancouver wa |
hey guys, ive already put one post on this site but i figured id introduce myself while i'm at it.
i'm emerson, livin in the pacific nw (damn rain, lol) my teacher hooked me onto motorcycles about ... |
|